No Hot Water? 6 Things to Check Before You Call a Plumber
No hot water is a call we get often across Liverpool and south-west Sydney, and it always seems to happen at the worst time: a full house, a cold morning or the week before Christmas. Some causes are simple to check yourself. Others need a licensed plumber or gas fitter. Here are six safe things to check first.

1. Is it one tap or the whole house?
If only one tap or shower runs cold, the problem is usually that tap or mixer, not the hot water system. If every tap is cold, the problem is the system itself, so keep going.
2. Electric system: check the switchboard
Look for a tripped switch labelled hot water. You can reset it once. If it trips again, leave it off and call a plumber. Repeated tripping often points to a faulty element or thermostat.
3. Off-peak power: has the tank run out?
Many electric systems in Sydney are on an off-peak (controlled load) tariff and only heat at set times, usually overnight. With extra guests or long showers, the tank can simply run empty. If the hot water comes back the next morning, your system may be too small for your household.
4. Gas system: is the gas on and the pilot lit?
Check that your other gas appliances work and that the valve at the gas meter is on. If your storage system has a pilot light, follow only the relighting steps on the label on the unit. If you smell gas, don't try to relight anything. Turn the gas off at the meter, get everyone outside and call a licensed gas fitter.
5. Continuous-flow system: note the error code
Instantaneous (continuous-flow) units usually show an error code on the controller or on the unit itself. Check that the unit has power, then write the code down. It helps us bring the right parts and fix it on the first visit.
6. Look for leaks around the tank
Water pooling around the base of a storage tank, rust, or a relief valve that drips all the time are warning signs. A leaking tank usually can't be repaired and will need replacing.
No hot water? When to call a plumber
Call a licensed plumber if you still have no hot water after these checks, if the tank is leaking or rusting, if a switch keeps tripping, if you smell gas, or if your system is more than about 10 years old. In NSW, gas and electrical work on hot water systems must be done by licensed tradespeople, so please don't open up the unit yourself.
MDG Plumbing repairs and replaces gas, electric, heat pump and continuous-flow systems across Liverpool, Hoxton Park, Horningsea Park, Casula, Prestons and Edmondson Park. See our hot water repairs and installation page, or for urgent help, our 24/7 emergency plumbers. Live near Liverpool? Visit our Liverpool plumber page, or call 02 9158 8513 any time.



Comments